Roll Bar Adapter Installation (RBA20M-1.3 and RBA20M-SC)
The RBA20M series of roll bar adapters are designed to solve one specific problem: aligning a pipe over a shaft cleanly ...
Posts by Chris Hume
Two-Speed Fan Control Using Dual Contactors
Many greenhouse ventilation fans support multiple speeds for better climate control and energy efficiency. This guide ex...
How to Recalibrate the Touchscreen on an AegisTec or AegisTecPlus Controller
If the touchscreen is unresponsive, “ghost touching,” or inaccurate, follow these steps in order.
Power the controll...
Correct Installation of Roll Bar Adapter
The roll bar adapter (65-RBA20M-1.3) connects an LVM60 or LVM100 motor to a 1.315" OD (1-⅝" nominal) roll bar pipe used ...
Wiring the AegisTecP Controller to the Westbrook MC100 Motor Vent Control
This resource provides the essential diagrams and instructions for successfully wiring the Advancing Alternatives AegisT...
Selecting the Appropriate Wire Size for 24V DC Motor Systems in Greenhouse Automation: Mitigating Voltage Drop in Long Runs
Introduction
At Advancing Alternatives, we specialize in greenhouse automation solutions, including control enclosure...
Using Advancing Alternatives Controllers with AC Motors: Important Considerations
Advancing Alternatives' Controller Interface Boxes (42-CB2, ECO-1100, and ECO-1150) are widely used for automating vario...
Linear Actuator Installation Overview
Linear actuators are essential components for automating ventilation in your greenhouse by opening and closing shutters ...
Converting AegisTecPlus Dry Contacts to Signal Contacts
The AegisTecPlus controller is designed with dry contacts (9 and 10), which means the controller does not supp...